Wednesday, July 10, 2013

Audio Booster Circuit

Small and portable unit, Can be built on a veroboard
The amplifiers gain is nominally 20 dB. Its frequency response is determined primarily by the value of just a few components-primarily C1 and R1. The values of the schematic diagram provide a response of ±3.0 dB from about 120 Hz to better than 20,000 Hz.Actually, the frequency response is ruler flat from about 170 Hz to well over 20,000 Hz; its the low end that deviates from a flat frequency response. 

The low ends roll-off is primarily a function of capacitor C1(since RIs resistive value is fixed). If C1s value is changed to 0.1 pF, the low ends comer frequency-the frequency at which the low-end roll-off starts-is reduced to about 70 Hz. If you need an even deeper low-end roll-off, change C1 to a 1.0 pF capacitor; if its an electrolytic type, make certain that its installed into the circuit with the correct polarity, with the positive terminal connected to Q1s base terminal.

Circuit Diagram:
Audio_Booster_Circuit Diagram Audio Booster Circuit Diagram

Parts Description
P1 100K
R1 47K
R2 470K
R3 10K
R4 560R
R5 270R
C1 0.1uF-25v
C2 3.3uF-25v
C3 470uF-25V
D1 5mm. Red Led
B1 9v Battery
J1 RCA Audio Input Socket
J2 RCA Audio Output Socket
S1 On-Off Switch



streampowers

Like the Post? Do share with your Friends.

IconIconIconFollow Me on Pinterest